Endüstriyel Kaldırma SistemleriMühendislik, üretim ve servis tek teknik merkezdeBroken wires, diameter loss, deformation, corrosion, elongation and connection damage must be recorded and evaluated systematically.
Inspection frequency and discard criteria depend on equipment type, manufacturer instructions, service conditions and applicable standards. Cleaning and lubrication do not replace dimensional inspection.
This content supports preliminary review. Equipment selection, structural calculations, compliance and commissioning decisions must be verified using site data and competent engineering.
Rated load is only the starting point. Lifting attachments, dynamic effects, duty, load spectrum and process risk must be evaluated together.
Read guide
Operating hours, cycles, average load ratio and load spectrum determine the required duty class of the crane and its mechanisms.
Read guide
The decision depends on capacity, span, hook approach, headroom, duty and maintenance access rather than tonnage alone.
Read guideSend a structured request for a new crane, modernization, maintenance, fault or spare parts.
